dump truck driver fails to lower bed hits overpass

#Dump truck driver fails to lower bed hits overpass how to
#Dump truck driver fails to lower bed hits overpass drivers
#Dump truck driver fails to lower bed hits overpass crack

The article entitled 'Truck driver charged in collision with bridge' (August 31, 2011), states,(2).Here are news reports about truckers who failed to avoid a low clearance and what happened:

Vehicles) and has low clearance information. If you're in the market for a Global Positioning System (GPS) in your truck, be sure that it is designed for large trucks (commercial motor 'This sort of culture of just following the GPS and almost ignoring the road signs has created this public hazard,' Paterson told reporters. One bridge in his county was hit nine times this year. New York state alone has seen more than 1,400 bridge strikes in the past 15 years, including 46 so far this year in suburban Westchester County, testing many old bridges already in need of repair, said County Executive Andrew J.

#Dump truck driver fails to lower bed hits overpass crack

New York state wants to crack down on truckers who rely on satellite devices to direct them onto faster but prohibited routes and end up crashing into overpasses that are too low for their rigs. 'GPS Causing Truckers to Crash Into Bridges'(1): In October 2009, reported in an article entitled They may think, 'But my GPS told me to go this way!' and proceed on without consulting their atlas, taking heed of warning signs or using common sense. Instructions), they have unwittingly set themselves up for In following the advice of the device (and not authoritative

#Dump truck driver fails to lower bed hits overpass drivers

Some professional drivers have relied on non-trucking specific GPS units to route them. Is perfectly passable for 13'6' tall trucks. Here, the low part of the bridge is 12'7' high, but the road We will be the first to admit that there are some roads (even some interstates and toll roads) where only a part of an overpass is too low for a standard 13'6' truck to go under (usually along the shoulder). See here a photo of a low clearance sign, telling drivers that the height is 11'7' tall. There was a partial listing of bridge heights online, but it appears to have been removed. Least in the continental USA) are well marked - both on the roads and in the front of a good motor carrier road atlas (like the one shown below). To the best of our knowledge, all permanent low clearances (at roads) in the USA have overpasses with more than enough space for commercial motor vehicles to safely pass under. Many large roads (particularly interstate and U.S. You're supposed to know well in advance of going under an overpass whether or not your truck has the clearance to do so safely.īasics about Low Clearance Bridges, Overpasses and Tunnels

#Dump truck driver fails to lower bed hits overpass how to

So, here is an overview of the subject and information about how to watch out for and avoid problems. When it comes to low clearance bridges and overpasses, we never cease to be amazed at how some professional truck drivers think they can outsmart them or squeeze underneath them anyway.īeing involved in an 'under blunder' of this kind is a preventable accident and the kind that helps you lose a truck driving job really fast. Low Clearance Bridges and Overpasses: How to Watch for and Avoid